controller optics
To configure the optics controller, use the
controller optics
command in the optics controller configuration
mode.
controller optics R/S/I/P
[
baud-rate rate
] [
bits-per-symbol value
] [
cd-max cd-max
|
cd-min
cd-min
|
cd-low-threshold cd-low
|
cd-high-threshold cd-high
|
dgd-high-threshold dgd-value
|
lbc-high-threshold lbc-value
|
osnr-low-threshold osnr-value description description
|
rx-high-threshold rx-high
|
rx-low-threshold rx-low
|
tx-high-threshold tx-high
|
tx-low-threshold
tx-low
|
sec-admin-state {maintenance | normal}
|
shutdown
|
transmit-power transmit-power
|
transmit-shutdown
|
perf-mon
{
enable
|
disable
} |
pm
[
30-sec |15-min | 24-hour
]
optics
[
report
|
threshold
{
cd
|
dgd
|
lbc
|
lbc-pc
|
opr
|
opt
|
osnr
|
pcr
|
pdl
|
pn
|
sopmd
|
rx-sig-pow
|
rx-sig-pow-dbm
}]
To configure the sub-sea parameters for the optics controller, use the following command:
controller optics R/S/I/P
[
filter-roll-off-factor value
|
filter-roll-off-factor value
|
rx-voa
target-power value
|
rx-voa fixed-ratio value
|
enh-colorless-mode value
|
enh-sop-tol-mode
value
|
nleq-comp-mode value
|
cross-pol-gain-mode value
|
cross-pol-weight-mode value
|
cpr-win-mode value
|
cpr-ext-win-mode value
|
submarine-params type value
]
For more information about the sub-sea parameters, see the
Configuration Guide for Cisco NCS 1004, IOS
XR Release 7.0.1
.
Syntax Description
Rack/Slot/Instance/Port of the optics controller.
R/S/I/P
Sets baud-rate for this controller in GBd.
baud-rate rate
Sets bits-per-symbol for this controller.
bits-per-symbol value
(Only for trunk optics controllers) Maximum chromatic dispersion.
The range is -350000 to +350000 ps/nm.
cd-max cd-max
(Only for trunk optics controllers) Minimum chromatic dispersion.
The range is -350000 to +350000 ps/nm.
cd-min cd-min
(Only for trunk optics controllers) Minimum acceptable chromatic
dispersion. The CD alarm is raised if the chromatic dispersion goes
below this value.
The range is -350000 to +350000 ps/nm.
cd-low-threshold cd-low
(Only for trunk optics controllers) Maximum acceptable chromatic
dispersion. The CD alarm is raised if the chromatic dispersion exceeds
this value.
The range is -350000 to +350000 ps/nm.
cd-high-threshold cd-high
Command Reference for Cisco NCS 1004
15
Commands
controller optics
