No
. 96-1886-01E
Rev
.
1.1
GTECH Aircon Radio (Model GWT154)
PAGE
40
OF
72
Code Name
Length Parameters
Description
0x09 Set PAN Scan
0
0
Start Active scan for PAN Coordinators
0x0A Get
Device List
Variable Address
List
Gets Associated End Devices list
EUI-64 and Short Address.
0x0B Join
PAN
10/26
Address
Network key
Short & EUI-64 address of End Device to join
to PAN (RF packet includes network key).
0x0C Get
ACL
Variable Access
Control
List
Get list of End Devices joined to this PAN
Coordinator radio.
0x0D Delete
ACL
10
Address
Removes a single End Device from the
Access Control List
0x0F Set End Device
1/2/8
Address
Select End Device radio using either
SYN(1), Short Address(2) or EUI-64(8)
0x11 Set
BAUD
2
BAUD
Sets the EIA485 BAUD rate for the currently
selected End Device
0x12 Get
RF Config.
3 Tx
power(dBm)
Antenna Sel.
Gets the transmit power setting & antenna for
the currently selected End Device
0x13 Set
RF Config.
3 Tx
power(dBm)
Antenna Sel.
Sets the transmit power & antenna for the
currently selected End Device
0x14 Get
Periph
Addr Mask
32 Bit-mapped
address mask
Gets the current Peripheral address filtering
mask contents
0x15 Set Periph Addr
Mask
32 Bit-mapped
address mask
Sets the Peripheral address filtering mask
0x16
Reserved
0x17
Reserved
0x18 Get
Ping
Response
10
Addresses
Reply with the address of End Device
responding to a Ping request.
0x19 Send
Ping
2/8
Address
Send Ping to End Device radio using either
Short Address(2) or EUI-64(8)
0x1A Get
RF
Registers
Variable CC2530
RF
configuration
Reply with current CC2530 radio
configuration register settings
0x1B Set RF Registers Variable CC2530 RF
configuration
Sets select CC2530 radio configuration
registers with compliance test parameters
0x1C Get
LoopBack
Variable PER
Packet Error Test Results
0x1D Set
Loopback
1
Mode
Selects diagnostic loopback test mode
0x1E Get
Version
Variable ASCII string
Firmware version in the format:
YYYY_MM_DD
0x1F Reset
/
Break
1
Target
Force all End Devices to Reset and assert a
Break condition on their 485 bus.
Table 15 - Coordinator Radio Command Codes