Output Listings and Error Handling
eld Manual—527255-009
6-96
Error Messages
same DLL name as the user library, but it is not the same file, nor does it look like a
copy of the same file.
Effect.
Warning (
eld
produces an output file, but it might not be what you intended).
Recovery.
This is not necessarily an error, although it may indicate that you didn’t do
what you intended to do. The DLL mentioned in the message will be used by
eld
during this link. For example, you may have specified this DLL to
eld
with a -l option,
and the program will remember that fact, so the operating system will look for this DLL
again at runtime. That’s probably okay. It’s just a possible source of confusion that the
user library has the same DLL name as this DLL. You probably should avoid this
situation. The DLL name inside the DLL should match the name that the DLL will have
at runtime. You should either build it with that filename to start with, which by default
makes its DLL name the same as that file name, or you should use the -soname option
when you build the DLL, to tell the filename to which you intend to rename the DLL
later. And you should build the user library in a different place, so that it has a different
DLL name inside it.
Cause.
You are building a program, and you are using a user library. A user library is
a DLL, and like any other DLL has a “DLL name” inside it.
eld
has also opened
another DLL, whose filename is shown in the message, and found that it contained the
same DLL name as the user library. Also, it probably is the same file, or a copy of the
same file, because it exports all the same symbols with the same addresses as the
user library.
Effect.
Warning (
eld
produces an output file, but it might not be what you intended).
Cause.
This is not necessarily an error, although it may indicate that you didn’t do
what you intended to do. The DLL mentioned in the message will be ignored by
eld
during this link, because it is redundant with the user library as far as doing fixups is
concerned. For example, you may have specified this DLL to
eld
with a -l option, but
the program will not remember that fact, so the operating system will not know to look
for this DLL at runtime, even if a different user library is used then. It’s hard to say
what all the consequences of this might be. You probably should avoid this situation.
The DLL name inside the DLL should match the name that the DLL will have at
runtime. You should either build it with that filename to start with, which by default
makes its DLL name the same as that file name, or you should use the -soname option
when you build the DLL, to tell the filename to which you intend to rename the DLL
later. And you should build the user library in a different place, so that it has a different
DLL name inside it.
1559 The DLL <filename> was found with the same export digest
as the user library.
1560 The -local_libname option is only allowed when you are
building a program.
Summary of Contents for eld
