3.
Add a security zone to the interface:
a.
Select
Configure>Security>Zones/Screens
.
b.
Add or select a security zone other than Null; for example,
Trust
. Assign the interface
to the zone.
c.
For Host Inbound Traffic-Zone, set the following:
•
System Services=
Allow All
•
Protocols=
Allow All
d.
Click
OK
to save changes, and select
Commit>Commit
to apply the configuration
and other pending changes.
4.
To use the port on the Mini-PIM, you must also set security policies. Select the following
settings:
a.
Select
Configure>Security>Security Policy
b.
Select
Global Options > Policy Options
.
c.
Set Policy Action: Default Policy Action=
Permit-All
d.
Click
OK
to save changes, and select
Commit>Commit
to apply the configuration
and other pending changes (if any).
For more information, in the J-Web interface, select
Configure>Interfaces
and click
Help
.
Using the CLI
To perform basic configuration of the 1-Port VDSL2 Annex A Mini-PIM and to configure
network interfaces for the services gateway with the CLI:
1.
Verify that the 1-Port VDSL2 interface is installed on the device:
show chassis hardware
2.
Verify the status of the interface:
show interfaces terse
3.
Assign the port an IP address:
set interfaces pt-1/0/0 unit 0 family inet address
interface address/destination prefix
4.
Add or select a security zone; for example, Zone1:
set security zones security-zone trust interfaces pt-1/0/0.0 host-inbound-traffic
system-services all
5.
Add or select security zones for host inbound traffic options protocols:
Copyright © 2017, Juniper Networks, Inc.
76
SRX300 Series and SRX550 High Memory Gateway Interface Modules Reference
