4 - 17
Software
4.3.10. Special commands
4.3.11. Commands for the initialisation modules
The initialization modules are a special variety of modules.
None of the commands described previously in this chapter can
be used here. On the other hand can the following commands
only be used with the initialization modules.
Com-
mand
Operand Byte
Time
[µs]
Function
C
*)
Z
*)
O_OFF
-
1,5
deactivates the actuating elements of all outputs
O_ON
-
1,5
activates the actuating elements of all outputs
RESET
-
200
resets all non-remanent outputs, markers, timers
and counters and stops program execution
WAIT
n
wait loop. Programm. delay = n (1...6 ) * 10 ms]
*) Influence on (C)arry-and
(Z)ero-Bit:
--
yes
++
no change
defined flag alteration
undefined flag alteration
Operand Data
type
Value
Byte Time
[µs]
Function
O00.00
BIT
1
1,0,1,1....
[16],1
Write logical value into 1bit address
Write logical values into 1bit and subsequent addresses
Write log. value into 1bit and the 15 following addresses
BM00.00
BYTE
75 *1)
1,18,0,125...
[8],128
"KUHNKE"
Write (decimal) value into 8bit address
Write values into 8bit and subsequent addresses
Write value into 8bit and the following 7 addresses
Write text into 8bit and subsequent addresses
BM00.00
WORD
19285 *2)
1,18,0,125...
[8],13283
Write (decimal) value into 16bit address
Write values into 16bit and subsequent addresses
Write value into 16bit and the following 7 addresses
BM00.00
TEXT
"KUHNKE"
Write text as from the specified address
"KUHNKE",
" MALENTE"...
Write texts as from the specified address
Summary of Contents for KUAX 680C
