M5251C3 Evaluation Board Users Guide, Rev. 0
2-12
Freescale Semiconductor
in conjunction with the -s option to indicate an optional offset for S-record download. The filename is
passed directly to the TFTP server and therefore must be a valid filename on the server.
If neither of the -c, -e, -i, -s or filename options are specified, then a default filename and filetype will be
used. Default filename and filetype parameters are manipulated using the SET and SHOW commands.
The DN command checks the destination download address for validity. If the destination is an address
outside the defined user space, then an error message is displayed and downloading aborted.
For ELF and COFF files which contain symbolic debug information, the symbol tables are extracted from
the file during download and used by dBUG. Only global symbols are kept in dBUG. The dBUG symbol
table is not cleared prior to downloading, so it is the user’s responsibility to clear the symbol table as
necessary prior to downloading.
If an entry point address is specified in the S-record, COFF or ELF file, the program counter is set
accordingly.
Examples:
To download an S-record file with the name “srec.out”, the command is:
dn -s srec.out
To download a COFF file with the name “coff.out”, the command is:
dn -c coff.out
To download a file using the default filetype with the name “bench.out”, the command is:
dn bench.out
To download a file using the default filename and filetype, the command is:
dn
2.4.11
GO (Execute)
Usage: GO <addr>
The GO command executes target code starting at address addr. The value for addr may be an absolute
address specified as a hexadecimal value, or a symbol name.
If no argument is provided, the GO command begins executing instructions at the current program counter.
When the GO command is executed, all user-defined breakpoints are inserted into the target code, and the
context is switched to the target program. Control is only regained when the target code encounters a
breakpoint, illegal instruction, trap #15 exception, or other exception which causes control to be handed
back to dBUG.
The GO command is repeatable.
Examples:
To execute code at the current program counter, the command is:
go
Summary of Contents for freescale M5251C3
