3. In the project explorer, you will find "lwip_freertos.h" under
Application\User
.
Figure 2.6. TrueSTUDIO Project Explorer
4. In “lwip_freertos.h”, change the WLAN_SSID, WLAN_PASSKEY, and WLAN_SECURITY defines to the values of the access point
you want to use.
5. Open Tera Term and connect to the STLink Virtual COM port of the NUCLEO board. In the “Setup\Serial Port” panel, select
115200
for the speed.
6. Press
F11
to build and then run the debugger
7. Once the STM32 has been flashed, and the debugger reaches the beginning of
main()
, press
F8
to run the demo
QSG166: WF200 Wi-Fi Development Kit Quick Start Guide
Getting Started with STM32 MCU, with FreeRTOS, and LwIP
silabs.com
| Building a more connected world.
Rev. 0.4 | 11
