OneStream Programming Guide
24
Select Interfaces
Place a tick in the checkbox next to each of the interfaces you wish to be used by this group. Note
that each interface can only be selected in 1 Group.
Hunting
Select the hunting type required – this controls in which order interfaces are selected to send calls
to. Options are:
a.
Sequential (Low First)
Calls are sent to the lowest available interface.
b.
Sequential (High First)
Calls are sent to the highest available interface.
c.
Cyclic
Calls are sent to interfaces in turn (i.e. A “Round Robin” setup).
Outgoing Options
Select the Supervision options for Outgoing calls from the following:
a.
No Supervision
This is the default option and provides no supervision.
b.
Loop Current Reversal On Connect/Disconnect
Provides a Loop Current Reversal when the outgoing call is connected and when
the call is disconnected.
c.
Loop Current Drop On Disconnect
Provides a Loop Current Drop when the outgoing call is disconnected.
Incoming Options
Select the Supervision options for Incoming calls from the following:
a.
No Supervision
This is the default option and provides no supervision.
b.
Loop Current Reversal On Disconnect
Provides a Loop Current Reversal when the incoming call is disconnected.
c.
Loop Current Drop On Disconnect
Provides a Loop Current Drop when the incoming call is disconnected.
CLI Options
Select the CLI Presentation options for Incoming calls from the following:
a.
No CLI
This is the default option and provides no CLI Presentation.
b.
Loop Current Reversal Before CLI
Provides a Loop Current Reversal before presenting the CLI.
c.
Ring Before CLI
Provides a Ring before presenting the CLI.
