7.7.9. CMD_GPIO_REMOTE_WRITECONFIG_IND
This command indicates that the remote device has written the free GPIOs of the radio
module.
Please note that only the GPIOs are part of this message, that have been
configured successfully. Failed attempts of GPIO configurations will not be
indicated by this message.
Format:
Start signal
Command
Length
Block
1
. . .
Block
n
CS
0x02
0xA8
2 Bytes
x Bytes
x Bytes
1 Byte
The
Block
structure is as defined in
CMD_GPIO_REMOTE_WRITECONFIG_REQ block structure
7.7.9.1. Example: Two GPIOs have been configured by the connected remote device
to output high
Start signal
Command
Length
Block
1
Block
2
CS
0x02
0xA8
0x08 0x00
0x03
0x01
0x02 0x01
0x03
0x02
0x02 0x01
A1
The two GPIOs with ID
0x01
and
0x02
have been configured by the connected remote
device to output high.
Proteus-III reference manual version 1.3
© August 2020
www.we-online.com/wireless-connectivity
110