ZXR10 8900 Series User Manual (Basic Configuration Volume)
Enabling ZTP
To enable ZTE Topology Protocol (ZTP), perform the following
steps.
Step Command
Function
1
ZXR10(config)#
ztp enable
This enables ZTP function
globally
2
ZXR10(config)#
interface
<
interface-name
>
This enters interface
configuration mode
3
ZXR10(config-if)#
ztp enable
This enables ZTP function on
an interface
4
ZXR10(config-if)#
exit
This exits interface
configuration mode
5
ZXR10(config)#
ztp vlan
<
vlanID
>
This conducts ZTP topology
collection on different VLANs
6
ZXR10(config)#
ztp hop
<
number
>
This sets the number of hops
of ZTP topology collection
7
ZXR10(config)#
ztp hop-delay
<
time
>
This sets each hop delay in
sending ZTP protocol packets
8
ZXR10(config)#
ztp port-delay
<
time
>
This sets delay in sending ZTP
protocol packets on the port
9
ZXR10(config)#
ztp start
This conducts once topology
collection
10
ZXR10(config)#
ztp timer
<
time
>
This sets ZTP timing topology
collection time
Setting up a Cluster
To set up a cluster, perform the following steps.
Step Command
Function
1
ZXR10(config)#
group switch-type
{
candidate
|
independent
|{
commander
[
iip-pooll
<
ip_addr
>{
maassk
<
net-mask
>|
llengtth
<
mask_len
>}]}}
This configures the role of
a switch and assigns an IP
address pool to the cluster.
2
ZXR10(config)#
group name
<
name
>
This changes the name of a
cluster.
3
ZXR10(config)#
group handtime
<
time
>
This configures the handshake
time.
4
ZXR10(config)#
group holdtime
<
time
>
This configures holdtime
between member switch
and command switch on a
commander switch.
124
Confidential and Proprietary Information of ZTE CORPORATION
