8.10.8
Set Time Selection
Command:
m,nPS
m,nPS sets the programmable pulse time selection to either UTC or
Local, where m = 0 for UTC and m = 1 for Local; n = 0 for Prog Pulse A,
n = 1 for Prog Pulse B. nPS returns current setting.
Response:
C
8.11
Miscellaneous Commands
8.11.1
Set Antenna Delay
Command:
nnnnnnAD
. . . AD sets antenna system delay compensation value. NOTE: Factory
default setting for the standard 6-meter (20-foot) cable is 24 ns. Time
range is from 0 to 999999 nanoseconds. The exact syntax for a 24-ns
delay is 24AD. See Section 7.1.3 for information on calculating cable
delay. AD returns current setting.
Response:
C
8.11.2
Set Out-of-Lock Time
Command:
(-)nLK
(-)nLK configures the Out-Of-Lock function in the Model 1095A/C. A
negative number turns the out-of-lock function OFF. n = 0 sets the out-
of-lock time to zero delay. n = 1 to 99 sets the amount of delay time
(in minutes) following loss of satellite synchronization before an out-of-
lock signal is generated and the relay contacts change state. LK returns
current setting.
Response:
C
8.11.3
Return Firmware Version
Command:
VE
VE returns the Firmware Revision date of the installed ROM.
Response:
dd mmm yyyyC
Where, dd = day of month, mmm = month, yyyy = year
93
