11.4 Custom Broadcast String Reference
113
ASCII Standard
Desired Output:
<
soh
>
ddd:hh:mm:ss
C
Input String Code: @@A/T01/d:/h:/m:/s/r
Input String Construction Notes: Note that the ordinary method of starting the ASCII Standard broadcast
is using the B1 or O1 command as described on page 94. Custom string entry always begins with the
@@A for strings output from the COM1 serial port, or @@B for strings output from the COM2 serial port.
Next, the T01 specifies the on-time character as a Hex 01, which is the Start of Header. Notice that these
characters are preceded by the “/”, which precedes each of the other (Table 11.7) characters. “d” is for
Julian Day, “h” if for hours, “m” is for minutes, “s” is for seconds, and “r” is for carriage return, line feed.
The “:” subdivides the Julian day, hour, minute and second, and no space between characters. After typing
in the Input String Code (as shown above), press the Enter key. The code’s acceptance is indicated by a
carriage return line feed.
Vorne Standard
Desired Output:
44hhmmss
C
55ddd
C
11nn
C
bel
Input String Code: 44/h/m/s/r55/d/r11/U/r/T07
Input String Construction Notes: Note that the ordinary method of starting the Vorne Standard broadcast
is using the B2 or O2 command as described on page 94. This input string code begins with the characters
“44”; note that these are printed as that and are not preceded by a “/”. “h”, “m” and “s” follow and include
a “r” for carriage-return, line-feed. “55” immediately follows the “r”, then a “d” for Julian day, followed
by another “r”. “11” immediately follows the “r”, followed by a “U” for unlock time and “r” for another
carriage-return, line-feed. Lastly, the “T07” specifies the on time character as the Hex 07, which sounds the
bel in the machine. Note that the “44”, “55” and the “11” are not preceded by a “/” since they are printed
as characters.
Status
Desired Output: ddd:hh:mm:ss I=nn:nn X=nn:nn
C
Input String Code: /[02?/d:/h:/m:/s /S01/r/:/]
Input String Construction Notes: Note that the ordinary method of starting the Status broadcast is using
the B4 or O4 command as described on page 95. This string begins with a true/false conditional 02, which
is a change of status. Since it is a part of the Table 11.7 character set, it must be preceded by the “/”. After
the “?”, appears the Julian day, hours, minutes and seconds that indicate the day and time that the status
changed. After the “s” (seconds) is an intentional space as shown in the input string code. After the space
is the intended “/” and “S01”, which indicates a status change string type of “01”. The “/:” separates the
“or” of the “true or false” conditions, only in this case there is no specified false condition.
Extended ASCII (DTSS MSG)
Desired Output:
C
Q yy ddd hh:mm:ss.000
Input String Code: /T0D/H0A/[03? /:?/] /y /d:/h:/m:/s.000
Input String Construction Notes: Note that the ordinary method of starting the Ext. ASCII broadcast is
using the B5 or O5 command as described on page 96. “T0D” sets the on time mark as a carriage return, and
Summary of Contents for 1201B
Page 4: ...iv ...
Page 153: ...B 7 Four Fiber Optic Outputs 135 Figure B 4 Jumper Locations ...