IDBlue – Communication Protocol v2.4.1
- 11 -
Data Capture
for Workforce
in Motion
Connected Mode
Normal
Normal
Normal
Normal
In
Normal
mode, when the hardware button is pressed, the device will:
• Indicate a start of RFID operations by turning the LED orange
• Attempt to scan a tag using the currently configured RFID protocol.
• If a tag is successfully scanned, the device will indicate with a green LED and audio beep (if
audio feedback is enabled).
• An asynchronous GET_TAG_ID response packet will be sent to the connected device.
Reactive
Reactive
Reactive
Reactive
In
Reactive
mode, when the hardware button is pressed, the device will:
• Send an asynchronous button pressed packet to the connected host.
Read Block N
Read Block N
Read Block N
Read Block N
In
Read Block N
mode, when the hardware button is pressed, the device will:
• Indicate a start of RFID operations by turning the LED orange
• Attempt to read block N (where N is the current value of the
BLOCKINDEX
property) using
the currently configured RFID protocol.
• If a tag is successfully scanned, the device will indicate with a green LED and audio beep (if
audio feedback is enabled).
• An asynchronous
READ_BLOCK
response packet will be sent to the connected device.
Write Block N
Write Block N
Write Block N
Write Block N
In
Write Block N
mode, when the hardware button is pressed, the device will:
• Indicate a start of RFID operations by turning the LED orange
• Attempt to write block N (where N is the current value of the
BLOCKINDEX
property) using
the currently configured RFID protocol, using the Block data found in the
BLOCKDATA
property.
• If a tag is successfully scanned, the device will indicate with a green LED and audio beep (if
audio feedback is enabled).
• An asynchronous
WROTE_BLOCK
response packet will be sent to the connected device.
Read Blocks
Read Blocks
Read Blocks
Read Blocks
In
Read Blocks
mode, when the hardware button is pressed, the device will:
• Indicate a start of RFID operations by turning the LED orange
• Attempt to read block N+M (where N is the current value of the
BLOCKINDEX
property and
M is the number of blocks to read from the
BLOCKCOUNT
property) using the currently
configured RFID protocol.
• If a tag is successfully scanned, the device will indicate with a green LED and audio beep (if
audio feedback is enabled).
• An asynchronous
READ_BLOCKS
response packet will be sent to the connected device.
Summary of Contents for IDBlue
