IDBlue – Communication Protocol v2.4.1
- 36 -
Data Capture
for Workforce
in Motion
SET_CONNECTED_ MODE (24h) [Deprecated]
Description
This request changes the current connected operating mode of the device (see below for possible
modes of operation).
Parameters
Operating mode
Operating modes for the device (when connected to a host):
Normal (00h or 03h)
Performs a GET_TAG_ID operation, trying to read the Id of whatever tag is in the RF field.
Reactive (01h)
Sends an event to the host when the button is pressed. This allows the host to control what
operations will occur on a button press.
Read Block N (04h) – Performs a READ_BLOCK operation. This mode is followed by the block
index of the block to be read.
Write Block N (05h) – Performs a WRITE_BLOCK operation. This mode is followed by the
block index and the block data to be written.
Result
1 if successful, 0 otherwise.
Returns
SET_CONNECTED_ MODE response packet or NACK.
GET_CONNECTED_ MODE (25h) [Deprecated]
Description
This requests the current connected operating mode. This is not necessarily the same value returned
by the GET_CONFIG request.
Summary of Contents for IDBlue
