33
®
G
G
G
G
G
3
rd
SMS - Other Configurations
The 3
rd
SMS text message contains several settings, as per the following syntax:
IP:xxxx;IS:abcdef00;MP:t1,DP:t2;C2:dddd;T:tt;Py;R:n;P:p;
xxxx
- these place cards represent the polarity of the Inputs, accepted values:
L
(Normally Closed Input activates when floating) or
H
(Normally Open Input activates when tied to Negative).
abcdef
- these place cards represent the Inputs that manage the “Special Functions” (
1
) or SMS Dialler functions (
0
).
Only the first 3 Input lines can be dedicated to “Special Functions”, in accordance with the following table:
Input Line no.
Place card
Special Functions
1
3
Enable/Disable Periodic Message
4
Send Periodic Message now
2
5
Clear Call Queue
6
Restore Reserved Outputs to Standby
3
7
Switch to GSM
8
Reserved (Alternative Dialling)
t1
- these place cards represent the time, in minutes, of the interval between Periodic messages.
Accepted values:
000001
through
999999
(this programming field requires 6 digits).
t2
- these place cards represent represent the time, in minutes, of the interval between Periodic Contact ID reports.
Accepted values:
000001
through
999999
(this programming field requires 6 digits).
dddd
- these place cards represent the Contact ID Communicator Customer Code.
tt
- these place cards represent the number of telephone actions (01 through 99) the BGSM-I must perform before reading
the SIM CARD credit balance. Enter the required number or enter 00 if this feature is not required.
y
- this place card represents the Priority. Accepted values:
I
(Interface priority) or
A
(Dialler priority).
n
- this place card represents the Digit to remove from the telephone number. Accepted values: 0 to 9.
p
- this place card represents the il Prefix. Accepted values: 0 to 9 (maximum 4 digits).
The following example shows the completed SMS text message:
IP:HHHH;IS:00100000;MP:001440,DP:001440;CD:ABCD;T:03;PI;R:1;P:081;
All 4 Input Lines Normally Open
Input Line 2 with Special Function ‘Clear Call Queue’
Periodic Message and Periodic Contact ID Report to be sent every 1440 minutes (24 hours)
The Customer Code for the Contact ID Communicator is ABCD
Pay-as-you-go Balance sent to the first telephone number in the BGSM-I phonebook every 3 telephone actions
Interface Priority
Digit to remove: 1
Prefix: 081
4
th
SMS - Contact ID Communicator Configuration
To configure the Contact ID Communicator — create a 4 section SMS text message, as per the following syntax:
x=ar,uuuu,eee;
where:
x
- this place card represents the Input line associated with the event.
Accepted values: A, B, C and D, in accordance with the following table:
Input Line 1
Input Line 2
Input Line 3
Input Line 4
A
B
C
D
a
- this place card represents the Contact ID Communicator Event report.
Accepted values: 1 (the Communicator will activate if the Input line is unbalanced) or 0 (the Communicator will not activate
if the Input line is unbalanced).
r
- this place card represents the Communicator Restoral report.
Accepted values: 1 (the Communicator will activate if the Input line restores to standby) or 0 (the Communicator will not
activate if the Input line restores to standby).
