DES-3000 Series Layer 2 Switch CLI Reference Manual
Command Parameters
create snmp host
<ipaddr> [v1 | v2c | v3 [noauth_nopriv | auth_nopriv | auth_priv]]
<auth_string 32>
delete snmp host
<ipaddr>
show snmp host
{<ipaddr>}
enable rmon
disable rmon
create trusted_host
[<ipaddr> | network <network_address>]
delete trusted_host
[<ipaddr> | network <network_address> | all]
show trusted_host
enable snmp traps
disable snmp traps
enable snmp authenticate
traps
disable snmp authenticate
traps
show snmp traps
config snmp system_contact <sw_contact>
config snmp
system_location
<sw_location>
config snmp system_name
<sw_name>
Each command is listed, in detail, in the following sections.
create snmp user
Purpose
Used to create a new SNMP user and adds the user to an SNMP
group that is also created by this command.
Syntax
create snmp user <SNMP_name 32> <groupname 32>
{encrypted [by_password auth [md5 <auth_password 8-16> |
sha <auth_password 8-20>] priv [none | des <priv_password
8-16>] | by_key auth [md5 <auth_key 32-32>| sha <auth_key 40-
40>] priv [none | des <priv_key 32-32>]]}
Description
The
create snmp user
command creates a new SNMP user and
adds the user to an SNMP group that is also created by this
command.
Parameters
<SNMP_name 32>
−
An alphanumeric name of up to 32 characters
that will identify the new SNMP user.
<groupname 32>
−
An alphanumeric name of up to 32 characters
that will identify the SNMP group with which the new SNMP user will
be associated.
encrypted
– Allows the user to choose a type of authorization for
authentication using SNMP. The user may choose:
•
•
by_password
– Requires the SNMP user to enter a
password for authentication and privacy. The password is
defined by specifying the auth_password below. This
method is recommended.
by_key
– Requires the SNMP user to enter a encryption
key for authentication and privacy. The key is defined by
26
