. . . . .
A D D R E S S T R A N S L A T I O N
Source NAT Configurations
Version 3R2
Security Appliance User Guide
10-3
CONFIGURING DYNAMIC IP (DIP) POOLS
Use dynamic IP (DIP) pools to create a pool of IP addresses to use for
source NAT policies. Use the
set interface
command with the
dip
option
to create a DIP pool of addresses on the egress interface:
set interface {interface name} dip {dip id} {start
address} {end address}
Addresses in the DIP pool must be on the same subnet as the
corresponding egress interface. You can create multiple DIP pools
created, each identified with a different dip-id number.
Use the
unset interface
command with the
dip
option to delete a DIP
pool from the interface:
unset interface {interface name} dip {dip id}
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S O U R C E N A T C O N F I G U R A T I O N S
This section describes two types of source NAT configurations that you
can use with this appliance:
• Source NAT, or Many-to-One with Port Address Translation
• Destination NAT and Port Mapping
