S E C U R I T Y Z O N E S A N D I N T E R F A C E S
Configuring Interface Modes
3-14
Security Appliance User Guide
Version 3R2
3
•
IP address/subnet
—The IP address and subnet assigned to the
interface.
•
Zone
—The zone assigned to the interface.
•
Media Access Control (MAC) Address
—The MAC address assigned
to the interface.
•
VLAN
—Identifies any VLANs configured on the interface.
•
Status
—Shows the link status of an interface as either U (up) or D
(down).
•
MTU Size
—Displays the current MTU size set for the interface.
•
Manage IP
—Shows the IP address from which the interface can be
managed.
•
Management Options
—Ping, ssh, http, https, snmp
•
Mode
—NAT, route, transparent
Use the
get interface
command to display information on a specific
interface:
get interface {interface name}
Use the
get interface all
command to display information on all
interfaces:
get interface all
E X A M P L E : G E T I N T E R F A C E E T H 0
cli-> get int eth0
if_index 1, mode route
admin status up, link status up
mtu 1500
configured type copper, speed auto, mode full-duplex
negotiated type copper, speed 1000, mode full-duplex
ip 192.168.65.49/24, mac 0060.2620.0094
manage ip 0.0.0.0, mac 0060.2620.0094
ping disabled, SSH disabled, HTTP enabled, HTTPS
enabled, SNMP disabled
