Programming
93
Instruction Manual - Enova DVX-325xHD/22xxHD All-in-One Presentation Switchers
Audio SEND_COMMANDs (Cont.)
AUDMIC_LIMITER_THRESH
Sets the threshold while limiting from the microphone for addressed by the D:P:S.
Syntax:
SEND_COMMAND <DEV>, "'AUDMIC_LIMITER_THRESH-<thresh>'"
Variable:
thresh = 0 to -60
Example:
SEND_COMMAND MICROPHONE_1, "'AUDMIC_LIMITER_THRESH--20'"
Sets the limiter threshold for the microphone port (#1 based on the D:P:S) to -20.
?AUDMIC_ON
Requests the status of the microphone port addressed by the D:P:S.
Syntax:
SEND_COMMAND <DEV>, "'?AUDMIC_ON'"
Example:
SEND_COMMAND MICROPHONE_1, "'?AUDMIC_ON'"
Returns a COMMAND string of the form: AUDMIC_ON-<setting>.
AUDMIC_ON
Enables or disables the microphone port addressed by the D:P:S.
Syntax:
SEND_COMMAND <DEV>, "'AUDMIC_ON-<setting>'"
Variable:
setting = on, off
Example:
SEND_COMMAND MICROPHONE_1, "'AUDMIC_ON-off'"
Disables the microphone port (#1 based on the D:P:S).
?AUDMIC_PHANTOM_PWR
Requests the setting for phantom power for a microphone.
Syntax:
SEND_COMMAND <DEV>, "'?AUDMIC_PHANTOM_PWR'"
Example:
SEND_COMMAND MICROPHONE_1, "'?AUDMIC_PHANTOM_PWR'"
Returns a COMMAND string of the form: AUDMIC_PHANTOM_PWR-<result>.
AUDMIC_PHANTOM_PWR
Enables or disables phantom power for the microphone port addressed by the D:P:S.
Syntax:
SEND_COMMAND <DEV>, "'AUDMIC_PHANTOM_PWR-<setting>'"
Variable:
setting = on, off
Example:
SEND_COMMAND MICROPHONE_1, "'AUDMIC_PHANTOM_PWR-on'"
Allows phantom power for the microphone port (#1 based on D:P:S).
?AUDMIC_PREAMP_GAIN
Requests the gain of the microphone before the amplifier.
Syntax:
SEND_COMMAND <DEV>, "'?AUDMIC_PREAMP_GAIN'"
Example:
SEND_COMMAND MIC_1,"'?AUDMIC_PREAMP_GAIN'"
Returns a COMMAND string of the form: AUDMIC_PREAMP_GAIN-<gain>.
AUDMIC_PREAMP_GAIN
Sets the pre-amplifier gain of the microphone addressed by the D:P:S to <value>.
Syntax:
SEND_COMMAND <DEV>, "'AUDMIC_PREAMP_GAIN-<gain>'"
Variables:
gain = 0-100. The units are in %.
Example:
SEND_COMMAND MIC_1,"'AUDMIC_PREAMP_GAIN-50'"
Sets the pre-amplifier gain for the microphone port (#1 based on D:P:S) to 50%.
?AUDMIC_STEREO
Requests the microphone port(s) that is/are in use.
Syntax:
SEND_COMMAND <DEV>, "'?AUDMIC_STEREO'"
Example:
SEND_COMMAND MICROPHONE_1, "'?AUDMIC_STEREO'"
Returns a COMMAND string of the form: AUDMIC_STEREO-<option>.
