If the FC variables are...
Then...
Different than you recorded earlier
1.
If you have not already done so, reboot
the replacement node to Maintenance
mode by pressing
Ctrl-C
when you see
the message
Press Ctrl-C for Boot
Menu
.
2.
Answer
y
when prompted by the system.
3.
Select the Maintenance mode option
from the displayed menu.
4.
Enter one of the following commands,
depending on what you need to do:
v
To program target ports:
fcadmin config -t target
adapter_name
v
To program initiator ports:
fcadmin config -t initiator
adapter_name
v
To unconfigure ports:
fcadmin config -t unconfigure
adapter_name
5.
Verify the values of the variables by
entering the following command:
fcadmin config
6.
Exit Maintenance mode by entering the
following command:
halt
After you issue the command, wait until
the system stops at the LOADER
prompt.
7.
Enter the following command at the
LOADER prompt:
printenv
The following line should be present in
the displayed
list:
bootarg.init.boot_clustered true
If it is not, you should issue the
following command to set the variable:
setenv bootarg.init.boot_clustered
true
8.
Enter the following command to boot the
replacement node:
boot_ontap
9.
After the node boots up, enter the
following command to verify that the
Fiber Channel configuration settings
have been restored:
run local fcadmin config
3.
If your configuration includes a gateway system, you must also adjust the
WWPN values in the host or volume groups associated with array LUNs on
the storage array. Installing a new controller module changes the World Wide
Port Name (WWPN) and World Wide Node Name (WWNN) values associated
126
IBM System Storage: N7000 Series Hardware and Service Guide
Summary of Contents for N7800
