M2Tech
www.m2tech.biz
MITCHELL
STEREO ANALOG ELECTRONIC CROSSOVER
REVISION P
RB
– DECEMBER 2020
Copyright © 2020, M2Tech Srl
23
Example 2:
#SF,B,B,2,004,02A
OK
Selects the cut-off frequency of the second 2-pole state variable filter in both channels of
way B.
The kind of filter is chosen by the SP command.
Example 3:
#SF,C,B,1,0F3
ERR
The command returns ERR because the ”q” parameter is missing.
8.1.2. Set Input (SI)
Input selection. The
MITCHELL
has two inputs: one single-ended and one balanced. Way A
is directly connected to the selected input, while ways B and C can be connected to the
selected input or to the output of the previous way (see examples).
The command has two parameters: the first one (w) indicates the way which will be
affected by the command; the second one (I) indicates the choice for that way.
Syntax:
#SI
,w,i
where:
w = [A,B,C]
i = [B,U] when w=A
[M,P] when w = B or C
A,B,C indicates the way the command is applied to.
B means “Balanced”.
U means “Unbalanced” (single-ended).
M means “Main input”
P means “Previous input”
Example 1:
#SI,A,U
OK
Selects the single-ended (Unbalanced) input. The signal from the single-ended input will
be sent to way A and, if not previously set otherwise, to ways B and C as well.
Example 2:
#SI,B,P
