M2Tech
www.m2tech.biz
MITCHELL
STEREO ANALOG ELECTRONIC CROSSOVER
REVISION P
RB
– DECEMBER 2020
Copyright © 2020, M2Tech Srl
30
A means “All-pass” (b).
H means “1-pole High-pass”.
L means “1-pole Low-pass” (b).
Example 1:
#GF,A,L,L
100
Returns the cut-off frequency of the 1-pole low-pass filter in the left channel of way A. as Q
is not defined for a 1-pole filter, q is “don't care” and it's not returned.
Example 2:
#GF,B,B,2
065,0A2
Returns the cut-off frequency of the second 2-pole state variable filter in both channels of
way B.
Please note that this command can't tell which output of the stave variable filter is
selected. Please use the GP command to get this information.
Example 3:
#GF,C,B,1
ERR
The command returns ERR because the it's not possible to read two channels at the same
time.
8.2.3. Get Input (GI)
Returns the selected input for the specified way. If the way is A, then the command returns
the chosen input on the back panel.
The command has one parameter: w indicates the way which input must be returned.
Syntax:
#GI
,w
where:
w = [A,B,C]
A,B,C indicates the way the command is applied to.
Example 1:
#GI,A
BALANCED
