29
[ state/bool]
:HOTKey
enable/disable hotkey mode
[ state/bool]
:LOCK
enable/disable keypad and rotary lock
[ state/bool]
:MONItor
enable/disable monitor to send "status" & V/I
message(GPIB & LAN not support )
[ state/bool]
:DHCP
select DHCP command
[ state/bool]
enables/disables DHCP mode
:IP
select IP command
[?/ xxx.xxx.xxx.xxx]
return IP address or set IP address
:CHannel
select channel
[ n]
channel number n: 1 - 3
:ADDRess
set up GPIB address for PPS3210
[?/ n]
return or set GPIB address n: 1 - 31
:DEFault
resume factory preset(password protected)
:PWD
enter password to verify
:PASSword
[ string]
the string must be less than 15 characters
:LOCAL ON
disable remote mode and back to local
mode
:GPIO
this command is valid when optional card
exists
[?/ level]
read or set up level of GPIO pins, level: 0 -
255
:DIRection n
set GPIO pins as input or output (0-input,
1-output), n: 0
– 255
GPIO
Pin 9
Pin 8
Pin 7
Pin 6
Pin 5
Pin 4
Pin 3
Pin 2
Pin 1
Bit
Bit 7
Bit 6
Bit 5
Bit 4
GND
Bit 3
Bit 2
Bit1
Bit 0
Value
128
64
32
16
X
8
4
2
1
MEASure
measure subsystem for channel n: 1 - 3
:CURRent[n]?
Return the floating point value of the DC
output current in amps for channel n: 1 - 3.
:VOLTage[n]?
Return the floating point value of the DC
output voltage in volts for channel n: 1 - 3.
:POWer[n]?
Return DC output power in watts.
:RESistance[n]?
Return DC output impedance in ohms.
SOURce
source subsystem
Summary of Contents for LPS 505N
