132
SPAN-SE User Manual Rev 1
Appendix B
Commands
B.4.27 SETETHPROTOCOL
Set Eth1 Protocol
The SPAN-SE has a 10/100 RJ-45 Ethernet port, which has a MAC address hard coded into flash and
user-configurable IP information. Port 3000 can be used for both TCP and UDP traffic but not
simultaneously. You must configure the system for either UDP or TCP communication and the
system
must be restarted
. The default is TCP.
To configure the ETH1 transport protocol, use the SETETHPROTOCOL command with its one non-
optional parameter.
IMPORTANT!: You must manually reset the system for this setting to take effect using the
RESET command or a power cycle. See also the RESET command on Page 122.
Abbreviated ASCII Syntax
Message ID = 1128
SETETHPROTOCOL IPProtocol
Abbreviated ASCII Example:
SETETHPROTOCOL UDP
RESET
Field
Field
Type
ASCII
Value
Binary
Value
Description
Binary
Format
Binary
Bytes
Binary
Offset
1
header
-
-
This field contains the
command name or the
message header depending on
whether the command is
abbreviated ASCII, ASCII or
binary, respectively.
-
H
0
2
IPProtocol UDP
0
User Datagram Protocol
Enum
4
H
TCP
1
Transport Control Protocol
(default)
