INTRODUCTION
STM32-P107 prototype board provides easy way for developing and prototyping with the new
STM32F107VCT6 connectivity line microcontroller, produced by STMicroelectronics. STM32-
P107 has JTAG port for programming and debugging, USB_OTG, user button, two status LEDs,
and most of the GPIOs are on extension headers where you can connect your additional circuits.
BOARD FEATURES
- CPU: STM32F107VCT6 32 bit ARM-based microcontroller with 256 KB Flash, 64 KB RAM,
USB OTG, Ethernet, 10 timers, 2 CANs, 2 ADCs, 14 communication interfaces
- JTAG connector with ARM 2×10 pin layout for programming/debugging
- Power jack for external power supply: suitable for (6.5-9)VDC or 6VAC
- USB OTG connector capable of powering the board
- USB host connector
- 100 Mbit/s Ethernet driver with RJ-45 connector
- RS232 driver with DE-09 female connector
- MiniSD card connector
- UEXT connector
- Two user-programmable buttons
- Reset button and circuit
- Two user-programmable LEDs
- Power-on LED
- 25 Mhz quartz crystal
- Extension port connectors for many of microcontrollers pins
- Prototype area
- Easy-to-change PTH jumpers
- Compatible with the bootloader tools provided by STM: "Flash Loader Demo" and "DfuSe Demo"
- PCB: FR-4, 1.5mm ~ (0.062)", soldermask, silkscreen component print
- Dimensions: (5.2×3.8)'' ~ (132×97)mm
ELECTROSTATIC WARNING
The STM32-P107 board is shipped in protective anti-static packaging. The board must not be
subject to high electrostatic potentials. General practice for working with static sensitive devices
should be applied when working with this board.
Page 3 of 23
