11
“LIFT”
Entering this routine the display will show near the word “LIFT”, 5 values (0 or 1) that
indicate the lift status:
1 if 0 the main board of the lift works correctly, if 1 the board doesn’t work.
2 if 0 the micro switch on delivery lift position is not pressed, if 1 the micro switch is
pushed ( or disconnected since is N.C. signal).
3 if 0 the micro switch on lift position isn’t pressed, if 1 the micro switch is pushed (or
disconnected since is N.C. signal).
4 if 0 the last command has been done correctly, if 1 the motor doesn’t move or the
encoder has no signal.
5 if 0 the last command has been done correctly, if 1 the lift has gone in timeout.
The number in the lower line (value can be increased or decreased with the UP and
DOWN buttons) shows the destination position of the lift. Pushing the Enter button the lift
goes to the selected position, pushing 0 the lift goes UP; pushing 5 the lift goes to the
delivery area.
Activation of HOME button will return the VMC to the code level at the "TEST” message.
PASS ROUTINE
This routine is used to access at the protected menu.
At the “PASS” prompt press enter button, display will be dark no chracters shown, press
the follow sequence of selection button 4-2-3-1-4 (password must be entered within 10
seconds) press Enter to confirm (selection 4) now you can see the first protected menu
“CASH” (use UP and DOWN button to cycle on the available menu).
CASH COUNTER ROUTINE (PROTECTED MENU)
If the ENTER button is activated at the "CASH" prompt the VMC will enter the cash
counter routine. Upon entry into this routine the display will show the "TOTAL" cash
counter (master plus slave machine). Using UP and DOWN button you can read the
counter on that order:
- "TOTAL"
Master plus slave total counter
- "TOTAL MASTER"
Only master total counter
- “SHELF X MASTER” Counter divided by shelf (x=1-8) for master
- “SEL. XX MASTER”
Counter per selection (xx =11-88) for master
- "TOTAL SLAVE"
Only slave total counter
- “SHELF X SLAVE”
Counter divided by shelf (x=1-8) for slave
- “SEL. XX SLAVE”
Counter per selection (xx =11-88) for slave
Press ENTER to go directly from master to slave counter.
Summary of Contents for Vendo G-SNACK
Page 1: ...G SNACK G SNACK PLUS MASTER SLAVE PROGRAMMING MANUAL...
Page 3: ...2...