Instructions for programming
Page 20 of 42
Name Submenu
Description
Default
Separate cashless price
» If the "Separate cashless price" is enabled:
The "coin" and "cashless" prices can be different.
Example: If the selection 11 has the "coin" price set to 0.50 and the
"cashless" price to 0.30, when you make a sale with cash the price will
be 0.50 and when you make a sale with the cashless the price will be
0.30.
» If the "Separate cashless price" is disabled:
The "coin" and "cashless" prices are equal. In this case the "cashless"
prices can't be set.
Example: If the selection 11 has set the "coin" price to 0.50 when you
make a sale with the coin or with the cashless the price will be 0.50.
To know how to set the "coin" prices see paragraph "4.3.4 ~ Coin / Key
price " on page 29;
No
Max cashless1/2
revalue
» This parameter determines the maximum cashless revalue.
65535
Bill Escrow enable
» This allows to also give banknotes as change. If enabled, and the last
banknote increases the credit over the maximum price, the bank note is
not inserted in the stacker, but remains available to be rendered as
change. If the function is disabled, the banknotes go directly into the
stacker.
Si
Bill token enable
» This function allows you to enable or disable the utilization of a special
token banknote that generates a free sale.
No
Bill revalue only
» If NO is set, then bill acceptance is managed by the coins in the tube +
bill escrow parameters.
If YES then bills are accepted only when a cashless key is inserted; the
key must be able to revalue and the bill type accepted are according to
the max revalue - actual key credit.
No
Key Always Idle
» This function allows to enable the payment device connected to the
vending machine in 2 way:
0 = Disable for both cashless
1 = Enable only for key1
2 = Enable only for key2
0
Cashless price display
» If NO the price of the cashless is not shown.
» If YES the price of the cashless is shown with the coin price.
No
Hide Cashless credit
» If NO the cashless credit is shown.
» If YES the cashless credit is not shown.
No
Vend timout on vend
request
» 0 function disabled.
» Range from 1 to 255 seconds.
If, after starting a cashless sale session, the payment device does not
respond within the set time, the distributor sends a payment cancellation
request to the payment device.
0
Exe Vend max wait
»
Parameter visible only with payment protocol “Executive”, “Executive
Pric
e Holding” and “Executive Price Holding Special”.
» Parameter used to set the waiting time of the vending machine to
receive the approval or denial of the sale by the payment system.
» Setting to 0 (zero) gives a default time of 3 seconds.
» Range from 0 to 250 seconds.
0
