91
StoneGate-Specific Commands
sg-bootconfig
[
--primary-console
=
tty0|ttyS
PORT,SPEED
]
[
--secondary-console
= [
tty0|ttyS
PORT,SPEED
]]
[
--flavor
=
up|smp
]
[
--initrd
=
yes|no
]
[
--crashdump
=
yes|no|Y@X
]
[
--append
=
kernel options
]
[
--help
]
apply
Can be used to edit boot command parameters for future
bootups.
--primary-console
=
tty0|ttyS PORT,SPEED
parameter
defines the terminal settings for the primary console.
--secondary-console
= [
tty0|ttyS PORT,SPEED
]
parameter defines the terminal settings for the secondary
console.
--flavor
=
up|smp
[
-kdb
] parameter defines whether the
kernel is uniprocessor or multiprocessor.
--initrd
=
yes|no
parameter defines whether Ramdisk is
enabled or disabled.
--crashdump
=
yes|no|Y@X
parameter defines whether
kernel crashdump is enabled or disabled, and how much
memory is allocated to the crash dump kernel (Y). The default
is 24M. X must always be 16M.
--append
=
kernel options
parameter defines any other
boot options to add to the configuration.
--help
parameter displays usage information.
apply
command applies the specified configuration options.
sg-clear-all
Use this only if you want to return a StoneGate appliance to
its factory settings.
Clears all configuration from the engine. You must have a serial
console connection to the engine to use this command.
sg-contact-mgmt
Used for establishing a trust relationship with the Management
Server as part of engine installation or reconfiguration (see
sg-
reconfigure
below). The engine contacts the Management
Server using the one-time password created when the engine’s
initial configuration is saved.
sg-logger
-f FACILITY_NUMBER
-t TYPE_NUMBER
[
-e EVENT_NUMBER
]
[
-i "INFO_STRING"
]
[
-s
]
[
-h
]
Can be used in scripts to create log messages with the
specified properties.
-f
FACILITY_NUMBER
parameter defines the facility for the
log message.
-t
TYPE_NUMBER
parameter defines the type for the log
message.
-e
EVENT_NUMBER
parameter defines the log event for the log
message. The default is 0 (H2A_LOG_EVENT_UNDEFINED).
-i "INFO_STRING"
parameter defines the information string
for the log message.
-s
parameter dumps information on option numbers to stdout
-h
parameter displays usage information.
Table A.1 StoneGate-specific Command Line Tools on Engines (Continued)
Command
Description
Summary of Contents for stonegate 5.2
