Tally Dascom DT-210/230 Programming Guide V1.1
- 2 -
Print downloaded bit image
[Format]
ASCII
GS
/ m
Hex
1D
2F m
Decimal
29
47 m
[Range]
0 ≤ m ≤ 3, 48 ≤ m ≤ 51
[Description]
Prints downloaded bit image defined by GS
∗
and using the mode specified by m.
m
Mode
Vertical direction
Horizontal direction
0, 48
Normal
180 dpi
180 dpi
1, 49
Double-width
180 dpi
90 dpi
2, 50
Double-height
90 dpi
180 dpi
3, 51i
Quadruple
90 dpi
90 dpi
Set graphics data
[Format]
ASCII
GS 8 L p1 p2 p3 p4 m fn [parameters]
Hex
1D 38 4C p1 p2 p3 p4 m fn [parameters]
Decimal
29 56 76 p1 p2 p3 p4 m fn [parameters]
• In the description below, only GS (L is used for explanation).
• Note that GS (L and GS 8 L have the same function).
• If the [parameters] in the Format column in the table below exceed 65533 bytes, use
GS 8 L.
• The only differences between GS (L and GS 8 L are as listed below. The format for GS 8
L is not provided in the following descriptions; however, [Range], [Default], [Description],
and [Notes] for parameters other than those listed in the table below are the same as for
GS ( L. <Parameters specifying the number of parameters after pH or p4>
Command
Parameters
Structure
Maximum value
GS ( L
pL, pH
2 bytes
65,535
GS 8 L
p1, p2, p3, p4
4 bytes
4,294,967,295
• Processes graphics data.
• pL, pH specify (pL + pH × 256) as the number of bytes after pH (m, fn, and
[parameters]).
• fn specifies the function.
• [parameters] specify the process of each function.
Summary of Contents for DT-210
Page 1: ......
