Power-Over-Ethernet Module
A D I V I S I O N O F T R I M B L E
Using the Optional Modules
63
1. POE_DHCP_MODE
: Sets DHCP mode ON or OFF. If DHCP is ON, Check for
Console debug log statements to learn the module IP and Port number details.
2. POE_IP_MODE
: Sets the PoE module configuration to be UDPclient or TCPclient or
TCPserver or HTTPclient.
You will need to edit this statement to select the mode::
#define
POE_IP_MODE ( POE_TCP_CLIENT )
Inside the parenthesis, enter one of the following values:
POE_UDP_CLIENT
[PoE interface configured as UDP client]
POE_TCP_SERVER
[PoE interface configured as TCP server]
POE_TCP_CLIENT
[PoE interface configured as TCP client]
POE_HTTP_CLIENT
[PoE interface configured as HTTP client]
Note
For HTTP client mode, there is no need to use this combination with TCP as
you must for the WiFi module.
If this mode is changed, you will likely need to reconfigure the settings for "Remote
host configurations" as shown below.
3. POE_LOCAL_PORT_NUMBER:
A PoE module port number is required if the module
is configured as a TCPserver
The best practice is to use port number within the range assigned for "Dynamic,
private or ephemeral ports".
http://en.wikipedia.org/wiki/Well-
known_ports#Dynamic.2C_private_or_ephemeral_ports
4. POE Static IP Attributes:
Manually assign the following attributes for the PoE
module StaticIP configuration if DHCP is OFF
POE_MODULE_IP_ADDRESS
POE_SUBNET_MASK
POE_GATEWAY_ADDRESS
5. Remote Host Attributes:
Some of these attributes will need to be configured for all
of the supported modes.
POE_REMOTE_HOST_NAME
Summary of Contents for Mercury xPRESS
