３．Communication commands
３－１．Communication commands
Command characters are ASCII data.
The delimiter of communication command is CR+LF in transmit and receive case.
In "all reply modes" , CT16-ER2 replies "OK" or "NG",
even if the command doesn't require a reply. Please see the section 3-7.
3-2. Read-out commands for counter set and the status of setting
3-2-1. Stop enable by count value
Type of command
ENCS
Enable to stop count by counter(CH7).
Also, memorized to ROM.
When count value of preset channel (CH7) reach to preset value,
count action automatically stopped.
On synchronous gate data acquisition mode, this command will be ignored.
3-2-2. Stop enable by timer value
Type of command
ENTS
Enable to stop count by timer.
Also, memorized to ROM.
When timer value reach to preset timer value, count action
automatically stopped.
On synchronous gate data acquisition mode, this command will be ignored.
3-2-3. Stop disable by counter timer
Type of command
DSAS
Disable to stop count by counter (CH7) or timer.
Also, memorized to ROM.
Counter doesn't stop automatically.
To quit counter action, it's valid for "STOP" command or "STOP" input
signal (TTL Level) or meet the condition of stopping GATE data acquisition
mode.
3-2-4. Inquiry of action mode
Type of command
MOD?
The latest counter mode is read.
Reply
R_SN_T_O
R: remote mode (fixed)
SN: single mode (fixed)
T: T/timer stop mode, C/counter stop mode, N/not stop mode
（When power switch on, the last mode is memorized）
O: O/counter On, F/counter off
（When power switch on, count function is "OFF".）
3-2-5. Setting and readout of preset counter
Type of command
SCPRdddd････
To set preset value dddd・・・・・ in decimal to preset counter.
Unit is Kcts.
Maximum value is 4,294,967 Kcts.
SCPRFdddd････
To set preset value dddd・・・・・ in decimal to preset counter.
Unit is cts.
Maximum value is 4,294,967,295 cts.
16/43
