4-4-3. Start synchronous timer clock data acquisition
Type of command
GTSTRT
Start to store clock synchronous data.
(Just after turn on power, it's stop condition)
Entering this command after preparation of section 4-2-1~3 and
4-3-1~2, CT16-ER2 starts synchronous clock signal data acquisition.
It stores signal data from current data address to end data address
synchronized by clock signal.
Inputting "STOP" command, data acquisition stops immediately.
4-5. Common commands on synchronous data acquisition
These are common commands both in GATE synchronous data acquisition and in inner TIMER.
4-5-1. Counter stop
Type of command
STOP
Stop counting immediately.
Data acquisition for synchronous GATE signal and internal timer also stops.
4-5-2. Read out the status of synchronous gate data acquisition
Type of command
GSTS?
Read out the data acquisition status.
Reply
Gate mode ON
Data acquisition on gate mode.
Timer Gate mode ON
Data acquisition on timer gate mode.
Gate Edge mode ON
Data acquisition on gate edge mode.
Now Hex Conversion
When the data is converted to hexadecimal number (the conversion
for high speed read), if data are acquired in the interval of 1ms~10ms,
the hexadecimal number conversion for high speed read does not meet
to the end of data acquisition. And this message is outputted to an
enquiry till the completion of a translation after data acquisition
completion.
Gate mode OFF
Gate mode is not active.
4-5-3. Read out all stored data(0~current data address)
Type of command
GSDAL?
Read out all stored data from 0 to current data address.
Current data address is set the next address to end data address
just after data acquisition.
Read out ch0~ch7.
ch0 ch1 ch2 ・・・・ ch7 timer
Reply example: 00123, 00456, 07890, ・・・・・ , 01234, 234567
← Data of No.0
00123, 00456, 07890, ・・・・・ , 01234, 234567
← Data of No.1
・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・
00123, 00456, 07890, ・・・・・ , 01234, 234567
← Data of No.n(n:acquisition end)
Data are output in order counter ch0 to ch7 and timer on one line.
Each data is output at 5 digits added 0 on head if the number of digit is below 5.
If over 5, each data is output at maximum digits of them.
Type of command
GSDALX?
Read out all stored data from 0 to current data address.
Current data address is set the next address to end data address
just after data acquisition.
Read out ch0~chX-1. X:16, 32, 48, 64
ch0 ch1 ch2 ・・・・ ch31 timer
Reply example: 00123, 00456, 07890, ・・・・・ , 01234, 234567
← Data of No.0
00123, 00456, 07890, ・・・・・ , 01234, 234567
← Data of No.1
・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・
00123, 00456, 07890, ・・・・・ , 01234, 234567
← Data of No.n(n:acquisition end)
28/43