PPP over ATM
Z-Edge 64 Configuration Guide
81
num-mode-enable: -------> {disabled}
....................
Save changes? [s]ave, [c]hange or [q]uit: s
Record updated.
7
Create an ip-interface-record profile, modify the following parameters:
zSH> new ip-interface-record pppoa/ip
Please provide the following: [q]uit.
vpi: ---------------> {0}:
vci: ---------------> {0}: 36
rdindex: -----------> {1}:
dhcp: --------------> {none}: ** read-only **
addr: --------------> {0.0.0.0}:
netmask: -----------> {0.0.0.0}: 255.255.255.255
netmask must be /32 for point-to-point connections
bcastaddr: ---------> {0.0.0.0}:
destaddr: ----------> {0.0.0.0}:
farendaddr: --------> {0.0.0.0}:
mru: ---------------> {1500}:
reasmmaxsize: ------> {0}:
ingressfiltername: -> {}:
egressfiltername: --> {}:
pointtopoint: ------> {no}: yes
mcastenabled: ------> {yes}:
ipfwdenabled: ------> {yes}:
mcastfwdenabled: ---> {yes}:
natenabled: --------> {no}:
bcastenabled: ------> {yes}: no
ingressfilterid: ---> {0}:
egressfilterid: ----> {0}:
ipaddrdynamic: -----> {static}: ppp
dhcpserverenable: --> {false}:
....................
Save new record? [s]ave, [c]hange or [q]uit: s
IP Interface record contains VPI/VCI values, but no 1483 layer could be found.
Could not automatically bind this IP Interface
New record saved
8
Because the system does not recognize an IP interface named pppoa, you
need to manually create the if-stack bindings:
zSH> stack bind
Enter the upper layer: pppoa/ip
Enter the lower layer: 1-1-1-0/ppp
Stack bind successful.
9
Use the stack show command to verify interface stacking:
zSH> stack show pppoa/ip
AAL5 layer: 1-1-1-0-hdsl2/aal5
ATM layer: 1-1-1-0-hdsl2/atm
Line Group: 1-1-1-0-hdsl2/other
Physical: 1/1/1/0/hdsl2
