Chapter 3: Accessing the PM IPDU via the Command Line Interface
15
Arguments
Examples
To set the threshold on PM IPDU number one to 5.6A, enter:
To set the threshold on PM IPDU number two phase Y to 5.6A, enter:
pm>
alarm 2 5.6 Y
To read the threshold, enter:
To set the threshold on segment A of a two-segment IPDU number 3-4.6A, enter:
assign
The assign command assigns management of an outlet to a given user. This command is available
to the admin user only.
Syntax
assign <outlet_number> <user>
<IPDU# or ID>
IPDU
number in a daisy chain or identification string set by the id
command
<threshold>
Value of the threshold current above which IPDU enters alarm condition.
X|Y|Z
Phase identification for three-phase model (PM42 IPDU) for which the
alarm threshold will be set. If no phase is given, the threshold will be set
to the same value for all phases
A|B
Segment identification for two-segment models (30/32A IPDU). If no
letter is given, the threshold for the total IPDU current will be set
pm>
alarm 1 5.6
pm>
alarm
pm>
alarm 3 4.6 A
pm_install_admin_user.book Page 15 Tuesday, March 24, 2009 3:02 PM
