Chapter 3: Accessing the PM IPDU via the Command Line Interface
19
dbsync
The dbsync command synchronizes the user database for all PM IPDUs in the chain. This
command is available to the admin user only.
Syntax
dbsync
Arguments
none
Examples
To synchronize the user database for all PM IPDUs in the chain, enter:
deluser
The deluser command deletes one username from the internal database. This command is available
to the admin user only.
Syntax
deluser <user>
Arguments
<user>
Desired username
Examples
To delete the user “rog”, enter:
display
Sets Display mode. <0|180> sets up the display orientation. For PM42 IPDUs, it can show current
(I) or voltage (V), and it cycles each <cycle time> seconds. In 30A IPDUs it may show 3 values;
current in segment [A], in segment [b] and the consolidated [C] when <cycle time> is defined. It
displays the letter [A] for .5 sec followed by the value of the current in seg.A, then the letter [b] for
.5 sec followed by the value of the current in seg.B, and then the letter [C] followed by the total
current in the unit.
If <cycle time> is not defined, it will either cycle manually (three-phase models) or display only
total current (two-segment models).
pm>
dbsync
pm>
deluser rog
pm_install_admin_user.book Page 19 Tuesday, March 24, 2009 3:02 PM
