Commissioning
EL6201
135
Version: 2.2
Bit
Description
0 - 7
Command sequence number from the request
8 - 14
Corresponding to bits 8 to 15 of the command call.
15
Error bit:
If bit 15 is set, this means that an error occurred during the execution of the command and an error
code is output in bits 31 to 24!
16 - 23
Address of the AS-i slave to which the command was sent.
Bit
Value
Description
24 - 31
0x00
Address modification was successful.
0x11
No slave exists with an address that was specified as the old address.
0x22
Address 0 is currently assigned to another slave. In order to change the address of an AS-i slave, the
EL6201 must first assign the address 0 to the slave in order to address it again afterwards from there.
0x36
A slave with the address that was specified as the new address already exists.
0x47
After deleting the old address, no slave with address 0 exists.
0x58
After deleting the old address, an error is generated during reading of the extended ID code 1 of slave 0.
Address changes for A/B slaves also require the extended ID code 1.
0x69
After writing of extended ID code 1, no slave with address 0 exists.
0x6B
After writing of the new address, the slave with the new address is not available during reading of the ID
code.
0x6C
After writing of the new address, the slave with the new address is not available during reading of the sta-
tus.
0x7D
The address could not be saved permanently (non-volatile).
0x7E
The extended ID code of an A/B slave could not be saved permanently (non-volatile).
0x7F
ID code 1 is invalid for A/B slaves
0x83
The new address is a B address.
If slaves are to be operated on two parallel addresses in address areas A and B, e.g. 10A (10) and 10B
(42), both slaves have to support B addressing. In this case, the parallel A address contains a slave that
does not support B addressing!
0x84
The new address is a B address.
The slave selected with the old address is, however, not an A/B-slave, i.e. it does not support the B-ad-
dresses (1B to 31B).
0x85
The new address is an A address.
Slave is not an A/B slave: the associated B slave for the new address exists.
Index 2010 AS-i string command
Object 0x2010 can be used to send string commands to the AS-i slaves (analog slaves with profile 7.4 and
CTT2 slaves with M4 profile). This is only possible if the AS-i master is already in the data exchange phase
and the "Data Exchange Active" bit in AS-i control is set.
