T: Trigger Output Delay Setting Command
Name Trigger
output delay setting command
Header code
T
Function
It sets the delay time of external output timing signal for strobe light.
@ 99
T
99999
R/W
FF
CR
LF
Command
Header
Channel
Output
delay time
Write
flag
Checks
um
Delimiter
Response
@ 99
O FF CR
LF
OK
command
Header
Channel Checksum
Delimiter
@ 99
N 9 FF
CR
LF
NG
command
Header
Channel Error
No.
Checks
um
Delimiter
The output delay time may be set from 0
µ
s to 10,000
µ
s.
Although it can be set increment of 1
µ
s as setting, it will actually be rounded in approximately 20
µ
s
increments at 300
µ
s or lower and 100
µ
s increments at 320
µ
s or higher.
D: Strobe Light Delay Setting Command
Name
Strobe light delay setting command
Header code
D
Function
It sets the delay time for strobe light.
@ 99
D
99999 R/W FF
CR
LF
Command
Header Channel
Strobe light
delay time
Write
flag
Check
sum
Delimiter
Response
@ 99
O FF CR LF
OK
command
Header Channel Checksum
Delimiter
@ 99
N 9 FF CR LF
NG
command
Header Channel Error
No.
Checks
um
Delimiter
Strobe light delay time may be set from 0
µ
s to 10,000
µ
s.
Although it can be set increment of 1
µ
s as setting, it will actually be rounded as shown at the
“2-5 Light Delay Time”.
(The delay time can not be set with 1
µ
s step)
