Dynamix IAD -162 Gateway
1: FSK(BELLCORE),
2: DTMF,
3: NTT.
-dtmfstart
DTMF CallerID Start Symbol.
-dtmfend
DTMF CallerID End Symbol.
Example:
sysconf -keypad 0 -eod 2 -callerid 1
usr/config$
Parameter Usages:
-print: Print current sysconf settings.
-idtime: Set the duration (in second) of two pressed digits in dial mode as timed
out. If after the duration user hasn’t pressed next number, it will dial out all number
pressed (1-10 seconds).
-service: set SIP Phone to be normal mode or under hotline mode.
(sysconf –service 0/1, 0 for normal service, 1 for hotline service.)
-keypad: DTMF replay type. When value is “1”, Dynamix IAD -162 Gateway will
transfer DTMF signal via RTP payload as defined in RFC2833. When the value
is set to “0”, the DTMF type is set as In-band, and 2 for SIP info DTMF.
-faxtype: FAX Payload Type. range: 96~128 inter-used:100,102~105.
-2833type: RFC2833 Payload Type. Range: 96~128 inter-used: 100, 102~105.
-lcdrop: Disconnect Supervision (Loop Current Drop) (ON:1 / OFF:0).
-droptime: Period of Loop Current Drop (ms).
-eod: It will transfer the DTMF in [#] if users disable the end of dial function. Users
have to press the keypad in [#] if the end of dial function is enable.
Note:
User can also define IP address here in P2P mode, once user press “#”,
Gateway will call out this IP address.
-callerid: Support Bell Core, DTMF caller ID and NTT caller ID function. After the
first ring at destination site, device will send line number as caller ID to called site.
-dtmfstart: DTMF Caller ID Start Symbol.
-dtmfstart: DTMF Caller ID End Symbol.
For example:
usr/config$ sysconf -print
System information
Gateway Service
: 0
- 78 -
