Input LED Output/Fault
LED
Condition (PWR-0307-01)
Condition (PWR-0307-02 and
later)
green solid amber blinking
Warning: FAN, OTP, OC, VOUT
OV/UV
Warning: FAN, OTP, OC, VOUT
OV/UV
green
blinking
amber solid
Not valid
Fault: Input OV
green
blinking
amber blinking
Not valid
Warning: Input OV, Input UV
green
blinking
off
Fault/Warning: Input OV
Not valid
green solid green blinking
PS_ON_L is high
PS_ON_L is high
green solid off
Fault: VSB SC, PS_KILL PSU not
inserted
PS_KILL PSU not inserted
OV - Over Voltage; OTP - Over Temperature Protection; UV - Under Voltage; OC - Over Current; VSB -
Standby Voltage
Define custom alerts
Two files on the system define alerts that could cause the LED behavior to change:
• The
/etc/alertd/alert.conf
file defines standard system alerts. Do not edit this file.
• The
/config/user_alert.conf
file defines custom settings. You should edit only this file.
1.
Open a command prompt on the system.
2.
Change to the
/config
directory.
cd /config
3.
Using a text editor, such as vi or Pico, open the
/config/user_alert.conf
file.
4.
Edit the file, as needed.
For example, add these lines to the end of the file to create a custom alert in which the front panel
LEDs indicate when a node is down:
alert BIGIP_MCPD_MCPDERR_POOL_MEMBER_MON_DOWN "Pool member (.*?):(.*?) monitor status
down."
{
snmptrap OID=".1.3.6.1.4.1.3375.2.4.0.10";
lcdwarn description="Node down" priority="1"
}
alert BIGIP_MCPD_MCPDERR_NODE_ADDRESS_MON_DOWN "Node (.*?) monitor status down." {
snmptrap OID=".1.3.6.1.4.1.3375.2.4.0.12";
lcdwarn description="Node address down" priority="1"
}
alert BIGIP_MCPD_MCPDERR_POOL_MEMBER_MON_UP "Pool member (.*?):(.*?) monitor status up."
{
snmptrap OID=".1.3.6.1.4.1.3375.2.4.0.11"
}
alert BIGIP_MCPD_MCPDERR_NODE_ADDRESS_MON_UP "Node (.*?) monitor status up."
{
snmptrap OID=".1.3.6.1.4.1.3375.2.4.0.13"
}
5.
Save the file and exit the text editor.
Platform Overview
16
