MPCe/LPCe Users Manual
36
Hex
Command
Description
Data Field
Response
Data/Response Interpretation
0D
GET SUPPLY STATUS
“1” or “2”
WAITING TO START
STANDBY
SAFE-CONN
RUNNING
COOL DOWN XX
PUMP ERROR XX
SAFE-CONN XX
RUNNING XX
INTERLOCK XX
SHUT DOWN XX
CALIBRATION XX
1 or 2 indicates the supply
XX is the pump error code
11
GET PUMP SIZE,
Reads pump size in liters per
second
“1” or “2”
ssss L/S
ssss
is pump size
12
SET PUMP SIZE,
Sets pump size in liters per second
“1, ssss” or
“2, ssss”
-
1, 2 indicates the supply
ssss
is pump size
1C
GET SUPPLY SIZE,
Reads high voltage transducer
size
“1” or “2”
“LARGE” or
“MEDIUM”
Large = 500 mA max current
Medium = 100 mA max current
1D
GET CAL FACTOR,
Reads the calibration factor that
modifies pressure
“1” or “2”
n.nn
n.nn range is 0.00 – 9.99
1E
SET CAL FACTOR,
Sets the calibration factor that
modifies pressure
“1, n.nn” or
“2, n.nn”
-
n.nn range is 0.00 – 9.99
20
GET HV STRAPPING,
Reads the supplies strapped high
voltage output
“1” or “2”
5600 or 7000
1, 2 indicates the supply
25
SET DISPLAY,
Changes the displays main
parameter
“1, P” or “2, P”
-
1, 2 indicates the supply
P = V (volts), C (current), or
P, (pressure)
33
SET AUTO-RESTART,
Sets supplies to automatically
restart on power up. This applies
to both HV sections.
“YES” or “NO”
-
-
34
GET AUTO RESTART,
Reads auto restart status of
supplies. This applies to both HV
sections.
-
YES or NO
-
35
GET AUTO-RESTART2,
Reads auto restart status of supply
two
-
YES or NO
-
36
SET AUTO RESTART2,
Sets indicated supply two to
automatically restart on power up
“YES” or “NO”
-
-
37
START PUMP,
Enables high voltage of specified
supply
“1” or “2”
-
1, 2 indicates the supply
38
STOP PUMP,
Disables high voltage of specified
supply
“1” or “2”
-
1, 2 indicates the supply
RS232/422/485 Remote TSP/NEG Related Commands
Remote TSP/NEG Related serial commands can be located in the TSP & Remote TSP/NEG Controller Manual
(part number 900016).
