33
IP CONFIGURATION
IP Configuration
The
8x8 Crosspoint Matrix for HDMI
supports IP-based control using Telnet, UDP, or the
built-in Web-based GUI. To set up IP control, the network settings must be configured via
RS-232. The default network settings for the matrix are as follows:
IP Address:
192.168.1.72
UDP IP Address:
192.168.1.80
Subnet:
255.255.255.0
UDP Port:
50008
Gateway:
192.168.1.254
UDP Remote Port:
50007
HTTP Port:
80
Telnet Port:
23
1.
Connect an RS-232 cable from the PC to the matrix. Also make sure to connect an
Ethernet cable between the LAN and the matrix.
2.
Launch a terminal emulation program (e.g. HyperTerminal) and use the RS-232
settings listed on page 32.
3.
Set the IP address for the matrix using the
#sipadd
command (see page 48
for details).
4.
Set the subnet mask using the
#snetmask
command (see page 49 for details).
5.
Set the gateway (router) IP address using the
#sgateway
command
(see page 43 for details).
6.
Set the Telnet listening port using the
#set_telnet_port
command
(see page 40 for details).
7.
Set the HTTP listening port using the
#set_http_port
command
(see page 38 for details).
8.
Power-cycle the matrix to reboot and complete all IP setting changes.
9.
Type the IP address that was specified in step 3, in a web browser to access
the Web GUI or use the same IP address to Telnet to the matrix.
UDP Configuration
1.
Set the UDP remote IP address for the matrix using the
#set_udp_remote_ip
command (see page 52 for details).
2.
Set the UDP listening port for the matrix using the
#set_udp_port
command
(see page 51 for details).
3.
Set the UDP remote port for the matrix using the
#set_udp_remote_port
command (see page 52 for details).
NOTE:
Depending upon the network, all related IP, Telnet, and
UDP settings will need to be assigned. Consult your network
administrator to obtain the proper settings.
