Instruction Manual PSx3xxMod
16
Reg.
Nr.
Name
Function
Type/
Range
Back
up
Delivery
State
R/W
Other settings
94-
103
general purpuse
10 general purpuse registers
16 bit
unsigned
yes
0
R/W
104
Umot limit
voltage limit for bit ‘motor power
present’
given in increments of 0.1 V
16 bit
unsigned
180 .. 240
yes
185
R/W
105
temperature limit
upper temperature limit in °C
16 bit
unsigned
10...70
yes
70
R/W
106-
115
reserved
-
16 bit
no
0
R/W
116
delivery state
reading directly after boot:
(value) = 0
content of memory correct
(value) > 0
content of memory incorrect
reading after saving:
(value) = 0
saving finished successfully
(value) AND (0xFC00) > 0
saving is still in progress (the
time for saving is up to 2000 msec)
(value) AND (0xFC00) = 0
AND
(value) AND (0x03FF) > 0
saving is finished incorrectly
writing ‘-2’:
generates the delivery state (sets
the device address to 1, baud rate
19200 bps, starts initial reference
loop, then positioning to the middle
of the measurement range)
A different device address or baud
rate is only active after a device
reset!
writing ‘-1’:
generates the delivery state
without modifying the device
address and the baud rate (starts
initial reference loop, then
positioning to the middle of the
measurement range)
writing ‘0’:
no action
writing ‘1’:
saves all parameters in the
EEPROM
A different device address or baud
rate is only active after a device
reset!
16 bit
signed
-
2…3
no
0
R/W
