30
ifm
Programming Manual BasicController relay CR0431 v03.03.00
05 / 2018
System description
Software description
>
STOP state
8288
A transition into this state is possible in the following cases:
• from the INIT state if no application program is loaded.
• From the RUN state if the following condition is met:
• The STOP command is sent via the CODESYS interface.
In the STOP state:
>
The outputs of the device are switched off.
>
Processing of the application program is stopped.
>
The LED lights green.
A transition from this state into one of the following states is possible:
• RUN
• ERROR
• FATAL ERROR
• INIT (after power-on-reset)
>
RUN state
8287
A transition into this state is possible in the following cases:
from the INIT state (autostart) if the following conditions are met:
• The operating voltage has reached a minimum value. AND:
• The application program exists.
From the STOP state:
• via the CODESYS command RUN.
• The operating voltage has reached or exceeded a minimum value.
In the RUN state:
>
The runtime system is running.
>
The application program is running.
>
The LED flashes green with 2 Hz.
The LED can be controlled differently by the application program
→ FB
SET_LED
(
A transition from this state into one of the following states is possible:
• INIT (after power-on-reset)
• STOP
• ERROR
• FATAL ERROR
Summary of Contents for BasicController CR0431
Page 228: ...228 10 Notizen Notes Notes...
