4
DEFINITIONS
FACTOR
- SCALING FACTOR; This portion of the programming menu sets up the input
scaling factors. Each input has a seperate dividing scale factor.
DP F A
-
DECIMAL POINT FOR FACTOR A; This sets a decimal for factor A if desired.
DP F B
- DECIMAL POINT FOR FACTOR B; This sets a decimal for factor B if desired.
RATE
-
RATE; This portion of the programming menu sets up the ratemeter information.
DP LOC
- DECIMAL POINT LOCATION; This sets a decimal location for the rate displays
(A, B and C). This is a fixed decimal and will effect the rate displays as well as presets A &
B.
A-B
- A - B; This sets the C display to show the difference of the A & B inputs.
A-B /B
- (A-B)
÷
B; This sets the C display to show the draw (ratio of A - B) of the A & B
inputs.
A/B
- A
÷
B; This sets the C display to show the ratio of the A & B inputs.
HI CPS
- HIGH COUNTS PER SECOND; This sets the A & B inputs for a high count speed
input ( 0 to 10 KHz).
LO CPS
- LOW COUNTS PER SECOND; This sets the A & B inputs for a low count speed
input ( 0 to 40 Hz).
NOR ##
- NORMALIZATION FACTOR; This is an averaging factor (00 to 99). Higher
settings provide more normalizing (averaging) for a more stable display. Derived from the
equation:
(OLD DATA x "NOR" + NEW DATA)
("NOR" + 1)
DLY ##
- DELAY FACTOR; The amount of time (02 to 24 sec.) that the unit will "look" for
valid input data before the display defaults to zero.
LOC
- LOCK; This portion of the programming menu sets the security lock parameters.
LC ALL
- LOCK ALL; This sets the unit to lock the program and the presets when the lock is
"on". The Presets can be viewed but not changed.
LC PRG
- LOCK PROGRAM; This sets the unit to lock the program when the lock is "on".
The Presets can be viewed and changed.