Market Central, Inc.
R1000 NBS/NAC
Page 9 of 16
SET TELNETENABLE ON[OFF]
GET TELNETENABLE
Set or display the current state of telnet based access. The network module will not accept any telnet requests when
telnet enable is off. Any change will not become permanent until a SAVE and RESET operation sequence is
performed.
SET TELNETPASSWORD string
GET TELNETPASSWORD
Set or display the current telnet password. Note that this is a case sensitive field. Any change will not become
permanent until a SAVE and RESET operation sequence is performed.
SET TELNETTIMEOUT seconds
GET TELNETTIMEOUT
Set or display the current telnet timeout in seconds. After a period of inactivity of this many seconds, the network
module will disconnect any current telnet session. Note that the telnet timeout cannot be disabled, it can however,
be set arbitrarily large. Any change will not become permanent until a SAVE and RESET operation sequence is
performed.
SET TELNETPORT N
GET TELNETPORT
Set or display the current telnet port number. Changing the telnet port number from the default can be used to
provide an additional level of security. Any change will not become permanent until a SAVE and RESET operation
sequence is performed.
SET AUTHENTICATIONTRAP ON[OFF]
GET AUTHENTICATIONTRAP
Set or display the current state of authentication error traps. Authentication traps will be generated when this
parameter is set to ON, and not when OFF. Note that this setting only affects the trap generation, and not how the
network module handles an authentication failure. An authentication failure generally means that an SNMP access
was attempted with an incorrect community name. Any change will not become permanent until a SAVE and
RESET operation sequence is performed.
SET MANAGER N X.X.X.X
Set SNMP manager N (1-16) IP address.
Up to 16 SNMP MANAGER IP addresses can be entered for destinations of trap messages. Trap messages will be
sent to all enabled MANAGER IP addresses. To remove an entry from the list, set the IP address to 0.0.0.0.
Any change will not become permanent until a SAVE and RESET operation sequence is performed.
SNMP Manager Table:
1: 192.168.1.113
2: 192.168.1.115
3: 192.168.1.149
4: 192.168.1.100
GET MANAGER N
Display SNMP manager N (1-16) IP address.
