SC200L Hardware Design
SC200L_Hardware_Design
33 / 103
3.9. UART Interfaces
SC200L provides two UART interfaces:
UART0
:
4-wire UART interface, hardware flow control supported.
UART1
（
DEBUG
）
:
2-wire UART interface; used for debugging by default.
The UART interface pin definition is as follows:
Table 10: Pin Definition of UART Interfaces
UART0 is a 4-wire UART interface with 1.85V power domain. A level translator should be used if
customers’ application is equipped with a 3.3V UART interface.
Figure 12: Reference Circuit with Level Translator Chip (for UART5)
The following figure is an example of a connection between SC200L and PC. A voltage level translator
and an RS-232 level translator chip are also recommended to be added between the module and PC. The
Pin Name
Pin No
I/O
Description
Comment
UART0_TXD
34
DO
UART0 transmit data
1.8V power domain.
If unused, keep it open.
UART0_RXD
35
DI
UART0 receive data
UART0_CTS
36
DI
UART0 clear to send
UART0_RTS
37
DO
UART0 request to send
DBG_RXD 93
DI
UART1 receive data.
Debug port by default.
DBG_TXD 94
DO
UART2 transmit data.
Debug port by default.
