Talk-a-Phone ETP-400KE, Installation & Operation Manual

Software Programming

L. 

Code Summary (for models ETP-400KSE and ETP-402KSE see page 17) 

Command Function 

 6 

Turn on Auxiliary Output 1 for 1 second 

*3* …[up to 8 digits]* 

Master Access Code entry to change Guard Access Code or 
Master Access Code  

(Default Code is *3*12345678*) 

*4* …[up to 8 digits]* 

Guard Access Code entry for phone programming 

(Default Code is *4**)

*5* 

Turns on unit speaker & microphone when you call in to the unit 
Effective for that call only 

*9* 

Elicit phone ID number 

*10* …[up to 8 digits]* 

Programs and stores a new Master Access Code 

*11* …[up to 8 digits]* 

Programs and stores a new Guard Access Code 

*12* …[six digits]* 

Program phone Identification number 

*13* …[up to 18 digits]* 

Programs the primary number called by Button #1 

*14*[1, 2, or 3]* 

Configures phone MODE 

(1 is default)

*17* …[minutes]* 

Sets conversation timer (1 – 4,320 minutes)  

(default is 12 

minutes)

*18* …[ring cycles]* 

Sets number of ring cycles (1 – 9) before phone aborts call and 
either redials the primary phone number or switches to the 
secondary phone number 

(default is 9 ring cycles)

*19* 

Makes call progress tones audible 

(default)  

[Mode 1] 

*20* 

Makes call progress tones silent  [Mode 1] 

*21* 

Configures phone for use with a Rolm PBX or a Mitel PBX 

*22* 

Cancels *21* command 

(default)

*23* …[up to 18 digits]* 

Programs the secondary number called by Button #1 

*24* …[0 – 6]* 

Sets "ON" time for Auxiliary Output #1 (incoming calls only) 

*25* 

Turn ON Auxiliary Output #1, effective for that call only 

*26* 

Turn OFF Auxiliary Output #1, effective for that call only 

*27* …[0 – 6]* 

Sets "ON" time for Auxiliary Output #2 (incoming calls only) 

*28* 

Turn ON Auxiliary Output #2, effective for that call only 

*29* 

Turn OFF Auxiliary Output #2, effective for that call only 

*40* …[0 – 10]* 

Sets delay before phone dials (0 – 10 seconds) 
May be used to wait to obtain PBX dial tone  

(default is 2 

seconds)

*49* 

Suppress automatic transmission of the phone ID number 

(default)

*50* 

Automatically transmit phone ID 

when guard station answers call

*53* 

Sets phone to disconnect if the Guard Station is silent 60 seconds 

*54* 

Phone will not disconnect if Guard Station is silent  

(default)

*55* 

Sets phone to disconnect if the Guard Station is silent 30 seconds 

*56* 

Sets Button #1 to activate Output #2 when pushed 

*57* 

Cancels *56* command 

(default)

*58* Record 

your 

identification 

message 

*59* 

Playback the recorded identification message 

*64* 

Make Auxiliary Output #1 drive an additional LED