6
3.2 Configuring by SMS commands
It is possible to configure the module and receive status information by sending the
appropriate command in SMS to the module’s phone number. First set the SUPERUSER
phone number from which the module will accept further SMS commands:
SMS command
Operation
SUPERUSER#
The module sets the sender’s phone number as
Superuser.
The module accepts this parameter only if
no Superuser has been set before!
SU=#
Deletes the current Superuser. The module accepts this
command only from previously set Superuser phone
number.
APN=
APN name
#
Sets the APN name
UN=
APN
user name
#
Sets the APN user name
PW=
APN
password
#
Sets the APN password
PH
X
=
phone number
#
Setting the phone numbers assigned to IP addresses:
substitute "X" with the ordinal number of the phone number
to be set or modified.
IP
X
=
IP address
#
Setting the IP addresses:
substitute "X" with the ordinal number of the IP address to
be set or modified.
PORT
X
=
port number
#
Setting the port numbers:
substitute "X" with the ordinal number of the IP address
port number to be set or modified.
TEST
X
=
Y
#
Setting the test report assigned to IP addresses: substitute
„X” and „Y” with the desired values:
X= the ordinal number of IP address
Y=0 (disabled)
Y=1 (enabled)
TSTFR
X
=
frequency
#
Setting the test frequency in seconds assigned to IP
addresses: substitute "X" with the ordinal number of the IP
address.
AUTOIP=
phone number
#
Setting the phone number for the “
Automatic IP selection”
option.
SELFID=
SIA user ID
#
Sets SIA user ID.
GSMS=
Y
#
Sets the
„GSM call filter”
option.
Y=0 (disabled)
Y=1 (enabled)
SPH
X
=
phone number
#
Setting the backup phone numbers for GSM call:
substitute "X" with the ordinal number of the monitoring
station phone number to be set or modified, dialed for
backup GSM call.
SFW=
phone number
#
Sets the phone number where incoming SMS messages
will be forwarded.
FWVER?#
Querying the firmware version of module.
