Required Hardware
ML605/KC705/VC707 board (use the corresponding design file).
■
AD9739A-FMC-EBZ board
■
Spectrum Analyzer
■
Required Software
Xilinx ISE (Programmer (IMPACT) is sufficient for the demo and is available on Webpack).
Use the latest version or the one used in the reference design.
■
A UART terminal (Tera Term/Hyperterminal), Baud rate 57600.
■
Bit file
Download the gzip file and extract the sw/cf_ad9739a_mb.bit file.
■
Running Demo (SDK) Program
If you are not familiar with ML605 and/or Xilix tools, please visit
http://www.xilinx.com/products/boards/ml605/reference_designs.htm
[http://www.xilinx.com/products/boards/ml605/reference_designs.htm]
for details.
To begin, connect the AD9739A-FMC-EBZ board to the FMC-LPC connector of ML605 board (see
image below). If using KC705 use FMC-LPC, if using VC707 use FMC1-HPC. Connect power and
two USB cables from the PC to the JTAG and UART USB connectors on the edge of the ML605. A
spectrum analyzer should be connected to the output SMA jack (OUT/J1). This quick start
program uses a 2.5GHz DAC clock and generates a 300MHz tone. Adjust your spectrum analyzer
accordingly. On the AD9739A-FMC board, ensure that the SPI source jumper (SPI SRC/P2) is set
Page 3 of 12
AD9739A Native FMC Card / Xilinx Reference Designs [Analog Devices Wiki]
5/22/2012
http://wiki.analog.com/resources/fpga/xilinx/fmc/ad9739a?force_rev=1
