Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
Troubleshooting Cisco G.SHDSL EFM/ATM
27
Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
DETAILED STEPS
Examples
The examples in this section show how to display the state of an EHWIC-4SHDSL-EA in a 2-wire
configuration, in
ATM Mode
and in
EFM Mode
. The commands include:
•
ATM Mode
–
show controllers shdsl detailed
–
show controllers ethernet
•
EFM Mode
–
show controllers shdsl detailed
–
show controllers ethernet
–
interface ethernet
–
Debugging Commands
ATM Mode
The following examples show the output of an IMA configuration in ATM mode.
•
show controllers shdsl detailed
•
show controllers ethernet
Command
Purpose
Step 1
show controllers shdsl
slot number/subslot number/0
[
detailed
|
brief
]
Example
:
Router#
show controllers shdsl 0/2/0 detailed
Displays the status of SHDSL controllers.
See the
“show controllers shdsl” section on
page 75
for more information.
Step 2
show interface ethernet
slot/subslot number/0
Example
:
Router#
show interface ethernet 0/1/0
Displays Ethernet interface status.
Step 3
show controllers ethernet
slot/subslot number/0
Example
:
Router#
show controllers ethernet 0/1/0
Displays information about the Ethernet
controller.
Step 4
show interface atm
slot/subslot number/0
Example
:
Router#
show interface atm 0/1/0
Displays ATM interface status.
Step 5
show controllers atm
slot/subslot number/0
Example
:
Router#
show controllers atm 0/1/0
Displays information about the ATM controller.
